您好,歡迎光臨萊州聚峰機械有限公司官方網站!

服務熱線

400-879-1999

你所在位置: 首頁 >> 混凝土攪拌車資訊 > 常見問題 >
常見問題

一輛攪拌車合格的技術標準必須滿足哪些?

來源:http://www.ilkyol.com/ 時間:2020-12-04

一、整車的外廓尺寸應符國家標準的規定。并按批準的產品圖樣及技術文件制造。
1、 The overall dimensions of the whole vehicle shall comply with the provisions of national standards. And according to the approved product drawings and technical documents.
二、外購件、外協件均應有制造廠的產品合格證,并符合相關標準的要求,經攪拌車生產廠檢驗合格后方可裝配。
2、 The purchased parts and outsourcing parts shall be provided with the product qualification certificate of the manufacturer and meet the requirements of relevant standards. They can be assembled after passing the inspection by the mixer manufacturer.
三、攪拌車的廠定大總質量不得超過底盤的大許用值,轉向軸(輪)載質量和側傾穩定角應符合GB7258的規定。
3、 The total mass of the mixer truck shall not exceed the maximum allowable value of the chassis, and the steering axle (wheel) load mass and roll stability angle shall comply with the provisions of GB7258.
四、焊縫應均勻、平直。無漏焊、裂紋、央渣、表面應無毛邊,包砂等現象。
4、 The weld shall be even and straight. There should be no welding leakage, crack, central slag, burr on the surface and sand inclusion.
五、所有外露黑色金屬表面均應作防銹處理。外表裝飾漆應美觀大方,符合GB7258的規定。
5、 All exposed ferrous metal surfaces shall be rust proof. The exterior decoration paint shall be beautiful and elegant, in accordance with GB7258.
混凝土攪拌車
六、從進料到輸送卸料完畢,允許的長時間為90mh,且攪拌筒按規定連續運輸不大于300轉。攪拌車行駛時,高車速不得超過如50km/h
6、 The allowable long time from feeding to the completion of conveying and discharging is 90mh, and the continuous transportation of mixing drum is no more than 300 revolutions. When the mixer is running, the high speed shall not exceed 50 km / h
七、裝入預拌混凝土在規定的攪動轉速和輸送時間運送到交貸地點后,泥凝土質量應符國標要求。
7、 After the ready mixed concrete is transported to the delivery place at the specified stirring speed and transportation time, the quality of the mud and concrete shall meet the requirements of the national standard.
八、進料斗出口尺寸不小于歷650mm,距地面高度應不大于3.8m。
8、 The size of the inlet hopper outlet shall not be less than 650mm, and the height from the ground shall not be greater than 3.8m.
九、水泥攪拌車的出料速度不小于0.65m3/min,出料殘余率小于2-5%。攪拌車的進料速度不小于2.7m3/min
9、 The discharging speed of cement mixer is not less than 0.65m3/min, and the discharge residual rate is less than 2-5%. The feeding speed of mixer truck shall not be less than 2.7m3/min
十、輸送應安裝牢固。各連接部分部件不應有損壞、變形等現象,不應有上車與底盤偏離原先的固定裝置的情況。
10、 The conveying should be installed firmly. All connecting parts shall be free from damage, deformation and other phenomena, and there shall be no deviation between the upper carriage and the chassis from the original fixed device.
十一、車在大總質量狀態下,以20km/h的速度府能通過14%的坡道外溢。
11、 Under the condition of large total mass, the vehicle can overflow through 14% ramp at the speed of 20km / h.
十二、制動性能府符合國標規定。行駛車外噪聲應符國標要求。
12、 The braking performance meets the national standard. The noise outside the vehicle shall meet the requirements of national standard.
十三、整車的各項密封性能良好,各密封面、管接頭及所有連接部位均不得有滲油漏氣的現 象。
13、 The sealing performance of the whole vehicle is good, and the sealing surface, pipe joint and all connecting parts shall be free of oil and gas leakage.
上一篇:為保證全自動混凝土攪拌車的驅動裝置完好可靠應如何維護
下一篇:1.5方混凝土攪拌車容量怎么計算?
tag:混凝土攪拌車,小型混凝土攪拌車,全自動混凝土攪拌車

一輛攪拌車合格的技術標準必須滿足哪些?

作者:中科聚峰混凝土攪拌車廠家 時間:2020-12-04

一、整車的外廓尺寸應符國家標準的規定。并按批準的產品圖樣及技術文件制造。
1、 The overall dimensions of the whole vehicle shall comply with the provisions of national standards. And according to the approved product drawings and technical documents.
二、外購件、外協件均應有制造廠的產品合格證,并符合相關標準的要求,經攪拌車生產廠檢驗合格后方可裝配。
2、 The purchased parts and outsourcing parts shall be provided with the product qualification certificate of the manufacturer and meet the requirements of relevant standards. They can be assembled after passing the inspection by the mixer manufacturer.
三、攪拌車的廠定大總質量不得超過底盤的大許用值,轉向軸(輪)載質量和側傾穩定角應符合GB7258的規定。
3、 The total mass of the mixer truck shall not exceed the maximum allowable value of the chassis, and the steering axle (wheel) load mass and roll stability angle shall comply with the provisions of GB7258.
四、焊縫應均勻、平直。無漏焊、裂紋、央渣、表面應無毛邊,包砂等現象。
4、 The weld shall be even and straight. There should be no welding leakage, crack, central slag, burr on the surface and sand inclusion.
五、所有外露黑色金屬表面均應作防銹處理。外表裝飾漆應美觀大方,符合GB7258的規定。
5、 All exposed ferrous metal surfaces shall be rust proof. The exterior decoration paint shall be beautiful and elegant, in accordance with GB7258.
混凝土攪拌車
六、從進料到輸送卸料完畢,允許的長時間為90mh,且攪拌筒按規定連續運輸不大于300轉。攪拌車行駛時,高車速不得超過如50km/h
6、 The allowable long time from feeding to the completion of conveying and discharging is 90mh, and the continuous transportation of mixing drum is no more than 300 revolutions. When the mixer is running, the high speed shall not exceed 50 km / h
七、裝入預拌混凝土在規定的攪動轉速和輸送時間運送到交貸地點后,泥凝土質量應符國標要求。
7、 After the ready mixed concrete is transported to the delivery place at the specified stirring speed and transportation time, the quality of the mud and concrete shall meet the requirements of the national standard.
八、進料斗出口尺寸不小于歷650mm,距地面高度應不大于3.8m。
8、 The size of the inlet hopper outlet shall not be less than 650mm, and the height from the ground shall not be greater than 3.8m.
九、水泥攪拌車的出料速度不小于0.65m3/min,出料殘余率小于2-5%。攪拌車的進料速度不小于2.7m3/min
9、 The discharging speed of cement mixer is not less than 0.65m3/min, and the discharge residual rate is less than 2-5%. The feeding speed of mixer truck shall not be less than 2.7m3/min
十、輸送應安裝牢固。各連接部分部件不應有損壞、變形等現象,不應有上車與底盤偏離原先的固定裝置的情況。
10、 The conveying should be installed firmly. All connecting parts shall be free from damage, deformation and other phenomena, and there shall be no deviation between the upper carriage and the chassis from the original fixed device.
十一、車在大總質量狀態下,以20km/h的速度府能通過14%的坡道外溢。
11、 Under the condition of large total mass, the vehicle can overflow through 14% ramp at the speed of 20km / h.
十二、制動性能府符合國標規定。行駛車外噪聲應符國標要求。
12、 The braking performance meets the national standard. The noise outside the vehicle shall meet the requirements of national standard.
十三、整車的各項密封性能良好,各密封面、管接頭及所有連接部位均不得有滲油漏氣的現 象。
13、 The sealing performance of the whole vehicle is good, and the sealing surface, pipe joint and all connecting parts shall be free of oil and gas leakage.

截屏,微信識別二維碼

微信號:ZKJF6688

點擊微信號復制,添加好友

 打開微信

漂亮人妻被强中文字幕_免费女人光着全身照片_强奷美女视频大全